Group News
July 4, 2008
Changes in the Executive Board
Mr. Masafumi Koga, after his turn as President of the PMG Group, retired effective June 12th. Dr. Michael Krehl, so far Executive Vice President of the PMG Group, and Mr. Takeshi Itaba, so far Executive Officer and Vice President at Mitsubishi Materials Corporation, were named co-Presidents of the PMG Group.
more
July 4, 2008
Awards for PMG Japan and PMG Füssen in Washington
Two awards for PMG Group at the 2008 Powder Metallurgy Design Excellence Awards Competition in Washington!
more
2005
JPMA 2005 New Materials Award for Powder Forged Valve Sheets for Gas Engine with high Adhesive Wear Resistance for Mitsubishi Materials Corporation
Developed powder forged valve sheets, which are composed of Fe-C-Cr-Mo-Co-Ni-Nb-CaF2, have been applied to general gas engine and truck gas engine...
more
2005
JPMA 2005 New Design Award for Development of P/M Parts for PCS (Pre-Crash Safety) for Mitsubishi Materials Corporation
These parts are used for the seat belt volume removing device corresponding to PCS (Pre-Crash Safety) system of the car, and it is composed of five parts...
more
2005
JPMA 2005 New Design Award for Sintered Stainless Pulley for Outboard Engine for Mitsubishi Materials Corporation
This sintered stainless pulley is used for high output 4-stroke outboard engine. Recently, outboard engine is required for good fuel consumption and clean emission, so 4-stroke engine has been replacing 2-stroke engine...
more
2005
JPMA 2005 New Design Award for Development of Sintered Piston Parts for Swing Compressor for Mitsubishi Materials Corporation
Sintered piston part was developed for swing compressor. Conventionally, piston part had been produced by the cast method to secure permanence of lever and air lock...
more
August 09 , 2005
Plansee and Mitsubishi Materials have signed the Joint Venture Agreement
Establishing a Global PM-Group
On August 9th, 2005, PLANSEE Holding AG (“PLANSEE”) and Mitsubishi Materials Corporation (“MMC”) have signed the joint venture agreement to merge their relevant business activities in the field of powder metallurgical (PM) products under a holding company based in Luxembourg. PLANSEE and MMC will hold each a 50 percent equity share in this joint venture...
more
